This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. ESSILOR KAPPA ERROR CODES FINDEEN
| Code | Category | User Reset | Parts Likely Needed | | :--- | :--- | :--- | :--- | | | Safety | Yes (Cycle power) | Door interlock | | E-201 | Motor overload | Maybe (After cooling) | Roughing wheel, motor | | E-306 | Bevel | Yes (Clean encoder) | Encoder strip, stylus | | E-413 | Pneumatic | Yes | Clamp belt, air filter | | E-507 | Wheel | No (Must dress) | Dressing stone | | E-722 | Communication | Yes | Tracer cable, PC | | E-888 | Software | Yes (Hard reset) | CF card, firmware | | E-990 | Parameter | No | Main PCB, backup |
The left clamping mechanism failed to secure the lens properly. Causes: Worn out or damaged adaptors. Debris buildup in the chuck shaft. Low pneumatic pressure (if air-assisted). Solutions: Clean the chucking pads and remove any debris. Check the air regulator pressure. essilor kappa error codes
: Hold the '9' key and press '5' (for edgers) or press simultaneously 'Clear' and '1' (for tracers). Run Tests (T1–T7) : T1 : Jaws/Clamping. T2 : Feeler Reproducer. T3 : Wheel/Carriage Rotation. T7 : Grooving/Drilling functionality. Proactive Maintenance Tips
: Relate primarily to the edger unit mechanical assemblies (e.g., door motors, grooving mechanisms, wheel spindles). This public link is valid for 7 days
If you want, I can:
The tracing stylus slipped out of the frame groove or wandered off track due to an extreme high-curve frame or debris. Can’t copy the link right now
: Ensure there is no lens in the trough and that the lens clamp shafts move freely.
When a new error appears, your course of action is clear: