V2000-c User Manual !!hot!! Online

: Connects directly to the +12V DC regulated power input.

Type the [4-Digit User Slot Number] (e.g., 0008 ) or swipe the card directly →right arrow Confirmation chirp sounds. Enter programming mode →right arrow Press [4] →right arrow

Connect the from the keypad to the Power Supply GND . v2000-c user manual

Shift the small black jumper block from its standard parking slot (Pins 1–2) over to .

The V2000-C is primarily a standalone RFID access control keypad supporting 500-1,000 users, 125KHz RFID cards, and 4-digit PINs, often in a waterproof housing. It is powered by 12V DC and features multiple entry methods, including card-only, PIN-only, or combined card and PIN. For the full manual, visit obohands.com : Connects directly to the +12V DC regulated power input

If you lose your custom Master Code, you can reset the device without wiping the enrolled user data. Disconnect the main power supply from the unit. Press and hold down the # key on the keypad. Reconnect the power while keeping the # key held down.

Check if the relay is set to Normally Open (NO) or Normally Closed (NC). 6. Maintenance and Safety Shift the small black jumper block from its

A typical V2000C system includes an electronic management board (which can be based on an Arduino platform) and a fingerprint reader, all powered by a 12V DC power supply.

The Ultimate V2000-C User Manual & Programming Guide The V2000-C is one of the most reliable and widely deployed standalone access control keypads on the market. Designed with a waterproof, vandal-resistant metal housing, it functions as a digital keyboard, RFID card reader, or a combination of both.

Feed the colored pigtail wiring loom cleanly through the gateway slot and clip the main unit into place. Core Wiring Color Codes

The relay holding time determines how long power cuts out (or triggers) after a valid entry scan. Enter Administrative Mode. Press (Orange LED illuminates). Input a [2-Digit Value] from 00 up to 99 seconds.