Avoid carpeted flooring, as fibers can block bottom ventilation slots.
When the Toshiba AW-J800AM encounters an operational problem, it stops the cycle and displays an error code on the digital screen alongside an audible alarm. Cause: The machine cannot drain water fast enough.
Ensure the top lid is closed completely, especially before a spin cycle begins. Unbalanced load
A: Some Toshiba pulsator models have a self-cleaning lint system. Check inside the tub rim – many still have a removable mesh filter.
To help you get the most out of your washing machine, tell me: toshiba aw-j800am user manual
: When using the "Greatwaves" course, the machine automatically initiates a self-clean process when water reaches level 2. The tub and pulsator rotate simultaneously to push water between the inner and outer tubs to remove residues. Soft-Close Lid
Open the lid and remove all internal packaging tape, accessories, and documentation. Step 2: Selecting the Location
Launches the selected wash cycle or pauses operation to add forgotten garments.
A buzzer will sound when the cycle finishes. Remove garments immediately to prevent wrinkling and musty odors. 5. Cleaning and Routine Maintenance Avoid carpeted flooring, as fibers can block bottom
| Problem | Possible Cause | Solution (from manual) | |---------|----------------|-------------------------| | Machine won't start | Power off, lid open, or paused | Check outlet, close lid firmly, press Start | | No water filling | Water tap off, or inlet filter clogged | Open tap, clean inlet filter | | Excessive vibration | Transit bolts still installed, or uneven load | Remove bolts (see installation), redistribute clothes | | Water leaks | Loose hose connection, or overfilled detergent | Tighten hoses, reduce detergent (creates excess suds) | | Spin cycle not working | Unbalanced load, or lid not fully closed | Rearrange clothes; ensure lid is locked | | Error code "E1" | Water supply issue | Check tap and inlet hose | | Error code "E2" | Drainage problem | Clean drain hose or pump filter (rear bottom panel) | | Error code "E3" | Lid lock failure | Power reset; call service if persists | | Error code "E4" | Overload or out of balance | Reduce load, restart spin cycle |
Turns the machine on and off. The machine automatically shuts down if left idle for several minutes after a cycle ends.
Wipe down the rubber lid seals and inner glass panel with a dry cloth.
"THE GREATWAVES™" which uses an S-type paddle and crystal inner drum to remove stubborn stains while protecting fabrics. Dimensions: Ensure the top lid is closed completely, especially
An intuitive combination of water flows (No Wrap, Upper Push, and Gush flows) and an s-type paddle designed to remove stubborn stains while protecting fabric.
Use a small pair of pliers or tweezers to pull the tiny mesh filter out of the water valve opening.
Rotate the feet clockwise to lower or counter-clockwise to raise the machine.
Verify that the machine is perfectly leveled on a solid floor.